Table of Contents
Advertisement
t
20. Slide rail stud
into slot on mounting bracket.
Stud should be pushed fully into slot until making
contact with base of slot.
y
21. Install washer
and locking nut
stud. Tighten nut until bracket is held flat against
platform rack.
DO NOT torque fasteners at this time.
22. Torque mounting bracket screws
specification.
TORQUE
Screws
106 in-lbs (12 N·m)
NOTICE
u
on each rail
r
to
r
:
Instr 9941299
23. Torque nuts
Torquing these nuts will require use of crowfoot
wrench. When applying final torque, crowfoot
wrench will need to be at a right angle to head of
torque wrench, as shown in illustration.
24. Release main straps of tent assembly. Allow
straps to hang down side of vehicle.
Rev 01 2023-05
Page 9 of 19
u
to specification.
TORQUE
u
Nuts
:
30 ft-lbs (40 N·m)
NOTE
Advertisement
Table of Contents
