Kenwood KDC-MP538U Service Manual page 13

Example of detail display: Display in the case of E2PROM
Write
MENU
CD Read : 1
Rom Write Mode
Rom Read Mode
Security Set
When [FNC] is
pressed briefly
Press [PLAY] / [PAUSE]
and when No
for one second.
is selected
Rom Write Mode
NO YES
When YES is selected and
[PLAY] / [PAUSE] is pressed briefly
Rom Writing ...
F/E→Mother
OK to transfer
ROM data
Rom Write OK
● Dual Zone
• If the [AUTO] or [TI] keys is pressed briefly while in a
source other than STANDBY, 2ZONE is switched be-
tween ON / OFF.
● Backup current measurement
If reset while in Acc OFF (Back Up ON) condition, MUTE
terminal goes off 2 seconds later, rather than 15 seconds.
(During this time, the CD mechanism does not function.)
TEST MODE
[FNC] key is inhibited during
Writing and Reading operations
F/E→Mother
NG to transfer ROM data
Rom Write NG
KDC-MP538U/MP6039/MP6539U/
W6041U/W6141UY/W6541U/W6641UY/X592
● Special displays while all lights are on
When all lights are on with STANDBY source, if the fol-
lowing keys are pressed, the following messages are dis-
played.
[FM] Key pressed briefl y: ROM correction version is displayed
key (Display) SYS_ROM_R1234
(Display) PAN_ROM_R1234
(Display) BOL_ROM_R1234
When E2PROM is not installed: ROM_ERR__
When not written in: ROM_R - - - -
When data not matching: ROM_R∗∗∗∗
∗1 "BOL ROM" can not be shown in KDC-MP6039.
[ ]
Key pressed briefl y: AUDIO data initialization
(Display) AUD_INIT
key
[ ] Key pressed briefl y: Forced Power OFF data displayed.
key Press and hold: To clear the forced power OFF infor-
mation. (Press and hold for 2 seconds while the forced
power OFF data is displayed.)
(Display) POFF_ - - - (No Forced Power OFF)
SEC ( Forced Power OFF because of
PNL ( Forced Power OFF because of
[AUD] Key pressed briefl y: iPod authentication IC installation
key status display
(Display) iPod_ OK_ (Installation status OK)
NG (Installation status NG)
[FNC] Key pressed briefl y: Multi-function display
key Press and hold: Version & Service information display
mode ON
Refer to the Table 1.
[1]~[6] Key pressed briefl y: Version & Service information display
Key mode ON
(Remote Refer to the Table 1.
controller)
[ ] Key pressed briefl y: CD information display mode ON
key Refer to the Table 2.
missing Security Code)
system μ-com and panel commu-
nication error)
13