Subscribe to Our Youtube Channel
Related Manuals for JWA BURGESS 76427
Summary of Contents for JWA BURGESS 76427
- Page 1 ASSEMBLY INSTRUCTION BURGESS 4 DRAWER TALL CHEST ITEM CODE 76427 Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia. For any assistance with assembly or for missing parts please refer to your receipt...
-
Page 2: Pre-Assembly Preparation
PRE-ASSEMBLY PREPARATION Before you start: 1.Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the product 2.Take care when li�ing. Product should be assembled as near as possible to the point of 3.Ensure that you have all required contents for complete assembly 4.Always read the assembly instruc�ons carefully before beginning assembly. -
Page 3: Parts List
PARTS LIST... - Page 4 PARTS LIST ITEM QTY NO. ITEM 8PCS 30PCS Φ6*35 30PCS 8PCS Φ15*10 Φ6*60 22PCS 48PCS Φ4*14 Φ6*30 8PCS 4PCS Φ4*50 2PCS 4PCS 24PCS 48PCS Φ4*35 Φ3*12 16PCS 8PCS Φ3*16 16PCS 8PCS 8PCS...
- Page 5 PARTS LIST ITEM QTY NO. ITEM 4 PCE TOP PANEL 1 PC DRAWER BOTTOM PANEL 1 PC LEFT SIDE PANEL 4 PCE 1 PC 2 PCE RIGHT SIDE PANEL LEGS SUPPORT PANEL 1 PC 1 PC BOTTOM PANEL LEGS SUPPORT PANEL 2 PCE 1 PC BACK PANEL...
- Page 6 STEP 1: STEP 2:...
- Page 7 STEP 3: STEP 4:...
- Page 8 STEP 5: STEP 6:...
- Page 9 STEP 7: STEP 8:...
- Page 10 STEP 9: STEP 10:...
- Page 11 STEP 11: STEP 12:...
- Page 12 STEP 13: STEP 14:...
- Page 13 STEP 15: STEP 16:...
- Page 14 STEP 17: STEP 18: To insert Drawers: a) Bring the ball-bearing slider on Drawer Glide Track(S1) forward to the front edge of(S1). b) Align the back open-end of the Drawer Glide Runner(S2) on each side of the drawer to fit squarely into the groove on the open front-end of(S1).Be sure the drawer/M 2 is not tilted or angled, and gently push in drawer squarely.
- Page 15 STEP 19: STEP 20: WALL...
- Page 16 ASSEMBLY IS COMPLETE CAUTION：Always Lift Your Furniture When Moving /Relocating - Do Not Drag. Dragging Can Cause The Legs To Bend/Break.
- Page 17 To protect your furniture, we suggest the following: • Avoid placing your furniture in direct sunlight. • Do not place furniture directly under windows. • Do not place sharp materials (knife, fork, etc.) directly onto your furniture as sharp material may scrape and damage the finish.
- Page 18 SAFETY BRACKETS INSTRUCTIONS 1. Attach one Mounting Plate to the wall with the Large Screws. Make sure to attach the Mounting Plate into a stud. If mounting into brick or masonry you will need to acquire wall anchors. 2. Attach the second Mounting Plate to the furniture frame with the Short Screws.
Need help?
Do you have a question about the BURGESS 76427 and is the answer not in the manual?
Questions and answers