Page 1
ASSEMBLY INSTRUCTION GERTRUDE BEDSIDE ITEM CODE 70485 Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia. For any assistance with assembly or for missing parts please refer to your receipt...
PRE-ASSEMBLY PREPARATION Before you start: 1. Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the product 2. Take care when lifting. Product should be assembled as near as possible to the point of use 3. Ensure that you have all required contents for complete assembly 4.
PARTS LIST M7X39mm M14.8X12mm M8X30mm M3.5X14mm 10pcs 10pcs 16pcs 12pcs M5X40mm M3X16mm 6pcs 4pcs 8pcs 4pcs 1pcs M4x30mm M3.5x14mm 1pcs 1pcs 1pcs 1pcs 1pcs 1pcs SIDE PANEL DRAWER SIDE PANEL SIDE PANEL DRAWER BACK PANEL SHELF DRAWER BASE BOTTOM PANEL DRAWER FRONT TOP PANEL BACK PANEL...
Page 4
CAM LOCK INSTALL METHOD AS FOLLOWS 1.1cm Step 1 Step 2 Step 3 Lock Fix cam nut into the bottom of hole then tighten it.
Page 11
SAFETY BRACKETS INSTRUCTIONS 1. Attach one Mounting Plate to the wall with the Large Screws. Make sure to attach the Mounting Plate into a stud. If mounting into brick or masonry you will need to acquire wall anchors. 2. Attach the second Mounting Plate to the furniture frame with the Short Screws.
Page 12
To protect your furniture, we suggest the following: • Avoid placing your furniture in direct sunlight. • Do not place furniture directly under windows. • Do not place sharp materials (knife, fork, etc.) directly onto your furniture as sharp material may scrape and damage the finish.
Need help?
Do you have a question about the GERTRUDE 70485 and is the answer not in the manual?
Questions and answers