Mp3(Wma)-Cd Playback; Skip/Search Function - Samsung yePP MCD-HF200 Instruction Manual

MP3(WMA)-CD Playback

1
Slide the Open button to
open the door, and insert
an MP3(WMA)-CD.
• Push the door to close it.
2 Press the Play/Pause
Track Number indicator
( √» ) button.
Album
normal
• The inserted MP3(WMA)-CD
Number
will be scanned for about
indicator
30~90 seconds. Playback will
then commence.
Your CD Player will take a
Album Name indicator
few moments to scan through
Title indicator
all the tracks and the sessions
recorded on an MP3(WMA)-CD.
3
To stop playback, press the
Stop ( ) button.
• Press the Stop ( ) button
again to switch off the unit.
Note • If a music file is corrupted and a particular section cannot be read, only
that section will be skipped. But if the file continues to be unreadable,
the player will skip to the next file.
• Files that do not conform to specifications (refer to P. 34) will be
skipped.
•
When the Open switch is slid to open the door, playback will stop.
•
The quality of MP3(WMA)-CD playback may vary depending on the condition of the
disc containing the music files or the condition of the recorder with which the disc
was created.
13
•
If different types of files or unnecessary folders are on the same disc, you will have
problems with playback.
Skip
Press and release the Iî or ïI button
during playback of a CD.
• Press the ïI button to play the next track.
Press the Iî button to go back to the beginning
of the current track. (Briefly press the Iî button
twice to repeat the previous track).
• Press the ïI button while the unit is in "Stop"
(no playback) mode. Track 2 will be played back.
Playtime
indicator Press the Iî button to play back the previous song.
Last Flat
L/R Channel
001 010 03 : 20
Level Indicator
128 44
Boyz II MEN
Anti-Shock
kbps kHz
Time Buffer
End [Boyz II MEN] Search
Level Indicator
Sampling Frequency
Indicator
Press and hold the Iî or ïI button
Bit rate indicator
during playback of a CD.
• Press and hold the Iî or ïI button.
The CD will playback in fast forward or fast reverse mode.
• Release the button to return to normal playback mode.
HOLD function
• Buttons pressed during CD playback will not function.
(On the display, the "Hold" indicator will flash.)
• Use the HOLD function when carrying your CD Player around with you.
Use of this function will allow you to conserve battery life as it prevents
the CD Player from being turned on if a button is pressed unintentionally.
• The remote control will still operate while the HOLD function on the
main unit is active.
• The main unit will still operate while the HOLD function on the remote
control is active.

Skip/Search function

Main Unit
Remote Control
Bottom of the Main Unit
14