ANZ WORLDLINE MOVE 5000 Self-Installation Manual

WORLDLINE MOVE 5000
We're pleased to provide you with your new Worldline MOVE 5000 terminal as part of your
Migration. Get up and running by performing the following self-installation steps:

INITIAL SETUP

1 Plug in the base of your terminal to a power outlet and place the terminal on the base.
2 Wait two minutes for the terminal to reach the main screen.
3 Press the green <ENTER> key to wake up the terminal and if terminal says WELCOME,
end process here. Your terminal is now ready to use.
If terminal displays either TERMINAL NOT ACTIVATED or TERMINAL MUST BE ACTIVATED,
press the '1' key. Terminal will display ENTER AMOUNT Press CANCEL and end process here.
Your terminal is now ready to use. The terminal will reactivate in about 10-20 seconds.
If there is an error during reactivation, consider setting your terminal to use a WIFI connection.
Instructions are available in the Quick Reference Guide enclosed with your terminal. If you need
further support, please contact ANZ Worldline Payment Solutions on 1800 039 025.

MERCHANT PASSWORD

Your password was sent to you via email and is used to process refunds, Mail Order Telephone
Order (MOTO) and Handkey transactions. If you need to change your password, contact us on
1800 039 025.
For more information on how to use your Worldline MOVE 5000 terminal please refer to the
Quick Reference Guide included with your terminal.
Turn the page for next steps on finalising your Migration.
Self - Installation Guide