Samsung SF-4300 User Manual page 87

07-Troubleshooting 2/5/99
Symptom
ÔThe selected port is currently
being used. Restart your
computer and try againÕ
message appears on the
screen.
ÔThe scanner driver is not
installed or an operating
environment is not set up
properly. Re-install the
scanner driver and try againÕ
message appears on the
screen.
ÔPort is disabled. Check if the
port is properly connected, or
power is on. Then restart
your computerÕ message
appears on the screen.
ÔPort is disabled. Check if the
port is properly connected,
power is on, scanner is not
busy. Then restart your
computerÕ message appears
on the screen.
9:42 AM Page 11
Scan error occurred and the scanning has not been completed
properly. Reset your computer.
Re-install the scanner driver. See page 1.21. If you still have
the same the problem, file setting required for I/O may not be
proper. Follow the instructions below :
1. Start your Windows.
2. In Windows 95, select Run from Start menu.
Windows 3.x users should select Run from File menu
under Program Manager.
3. Type ÔsyseditÕ, then click OK.
4. Select SYSTEM.INI file, and set the file as shown below.
[386 Enh]
device=vecp.386
LPT1TurnAroundDelay = 50
5. Restart your Windows.
I/O error occurs during scanning. Check for bad cable and the
cable connection. If you still have the same message, open the
System.ini file in the Windows directory as described above,
and increase time as much as required in increments of 10.
The printer cable may be improperly connected or the power
amy be off. Turn the power on. If you still have the same
problem: turn the computer and printer off, and back on after
about 10 seconds, then try again.
Cause and Solution
Troubleshooting 3.11