Table of Contents
Advertisement
PART IDENTIFICATION CHART
Use the drawings below to identify small parts used for assembly. The number in parentheses below each draw-
ing is the key number of the part, from the PART LIST near the end of this manual. The number following the key
number is the quantity used for assembly. Note: If a part is not in the hardware kit, check to see whether it is
preattached. Extra parts may be included.
ASSEMBLY
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you fi nish all assembly steps.
• After shipping, there may be an oily substance on
the exterior of the incline trainer. This is normal.
If there is an oily substance on the incline trainer,
wipe it off with a soft cloth and a mild, non-abra-
sive cleaner.
3/8" Star
M4 x 16mm
Washer (3)–8
Screw (8)–6
3/8" x 5 1/2" Screw (1)–4
• Assembly requires the following tools:
the included hex keys
a standard screwdriver
To avoid damaging parts, do not use power tools.
6
Advertisement
Table of Contents
