Table of Contents
Advertisement
■ Outdoor Unit
$
■ Indoor Unit
1. Air filter
2. Titanium Apatite Photocatalytic
Air-Purifying Filter
3. Air inlet
4. Front panel
5. Panel tab
6. Room temperature sensor:
• It senses the air temperature around the unit.
7. Display
8. Air outlet
9. Flap (horizontal blade): (page 12.)
10. Louvers (vertical blades):
• The Louvers are inside of the air outlet.
(page 12.)
11. Operation lamp (green)
12. TIMER lamp (yellow): (page 14.)
■ Outdoor Unit
15. Air inlet: (Back and side)
16. Air outlet
17. Refrigerant piping and inter-unit cable
Appearance of the outdoor unit may differ from some models.
#
13. Indoor Unit ON/OFF switch:
• Push this switch once to start operation.
• The operation mode refer to the following table.
• This switch is useful when the remote controller
14. Signal receiver:
• It receives signals from the remote controller.
• When the unit receives a signal, you will hear a
18. Drain hose
19. Earth terminal:
• It is inside of this cover.
Push once again to stop it.
Temperature
Mode
FTN
COOL
FTYN
AUTO
is missing.
short beep.
• Operation start .............beep-beep
• Settings changed..........beep
• Operation stop ..............beeeeep
%
&
'
Air flow
setting
rate
22°C
AUTO
25°C
AUTO
5
Advertisement
Table of Contents
