Table of Contents
Advertisement
EYE PROTECTION
Which conforms to ANSI/ CE specifications and provides protection against flying particles both from
the FRONT and SIDE should ALWAYS be worn by the operator and others in the work area when
connecting to air supply, loading, operating, or servicing this tool. Eye protection is required to guard
against flying fasteners and debris, which could cause severe eye injury. The employer and/or user must
ensure that proper eye protection is worn. Eye protection equipment must conform to the requirements
of the ANSI Z87.1 and 89/686/EEC, and provide both frontal and side protection.
NOTE
Non-side shielded spectacles and face shields alone do not provide adequate protection.
TO PREVENT ACCIDENTAL INJURIES
．Never place a hand or any other part of the body in the discharge area of tool while the air supply is
connected.
．Never point the tool at anyone else.
．Never engage in horseplay.
．Never pull the trigger unless the nose is directed at the workpiece.
．Always handle the tool with care.
．Do not pull the trigger or depress the trip mechanism while loading the tool.
Loading the Tool
Open the Magazine
Depress the door latch, and
swing the magazine cover
and door open.
Nail Length Adjustment
The nail support can be
moved up and down to
different settings. To change
setting pull up on the post
and twist to the correct step.
The nail support should be
adjusted correctly to the
position indicated in inches
and millimeters inside
magazine.
OPERATION : FASTENER LOADING
Nail Loading
Place a coil of nails over
the post in the magazine.
Uncoil enough nails to reach
the feed pawl, and place
the second nail between the
teeth on the feed pawl. The
nail heads fit in slot on nose.
14
Swing Cover Closed
Close the door
Check that latch engages.
(If it does not engage, check
that the nail heads are in the
slot on the nose.)
Advertisement
Table of Contents
