VR3G-1 VR3G-1P This document serves as a mounting and installation guide for the VR3G-1 and VR3G-1P Vandal Restistant IP and SIP Intercom Stations. For more information and instructions on configuration of the VR3G-1 and VR3G-1P go to wiki.zenitel.com/wiki/Main_Page. The Vandal Resistant series consists of the following components:...
Installation VR3G-1/VR3G-1P can be powered by PoE. This is done by connecting an Ethernet cable to the LAN port of the station and a PoE switch. NB! If PoE is used, the station must be installed using a shielded Ethernet cable with grounding at the switch end.
Page 4
Flush mounting When flush mounting vandal restistant station, use the 3 Gang Flush Mount back box. Insert and secure the 3 Gang Flush Mount back box into designated slot in the wall. Make sure that the box is squarely all dimensions in mm mounted and the front surface flush with the wall surface.
The Vandal Resistant Station can operate in three different modes, IK Rating IK10 ICX-AlphaCom, Edge and SIP, depending on what kind of server it is registered to. Enter the link or scan the QR-code below to go to Zenitel Relative humidity < 95% not condensing Wiki for configuration instructions.
Page 6
The WEEE Directive does not legislate that Zenitel, as a ‘producer’, shall collect ‘end of life’ WEEE. This ‘end of life’ WEEE should be recycled appropriately by the owner who should use proper treatment and recycling measures. It should not be disposed to landfill.
Page 7
Zenitel and its subsidiaries assume no responsibility for any errors that may appear in this publication, or for damages arising from the information therein. Zenitel, Vingtor-Stentofon and Phontech products are developed and marketed by Zenitel. The company’ s Quality Assurance System is certified to meet the requirements in NS-EN ISO 9001. Zenitel reserves the right to modify designs and alter specifications without notice.