Priefert RC22SP Installation Instructions Manual

Steer pusher

Advertisement

Quick Links

RC22SP Steer Pusher
Installation Instructions
www.priefert.com 800-527-8616
AI_RC22SP_v1-0623.indd

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RC22SP and is the answer not in the manual?

Questions and answers

Summary of Contents for Priefert RC22SP

  • Page 1 RC22SP Steer Pusher Installation Instructions www.priefert.com 800-527-8616 AI_RC22SP_v1-0623.indd...
  • Page 2: Using This Manual

    Follow all safety warnings and recommendations. parts and equipment needed to service your Steer Pusher or your RC22. The parts on your RC22SP or RC22 have been specifically designed and should only be replaced with genuine Priefert parts. Therefore, should you require replacement parts, contact our Support Center.
  • Page 3: Safety Alert Symbols

    Thoroughly read and understand the installation, operation, references and move depending on a handlers position relative to their point of balance. other material supplied with the RC22SP. If the installer or operator cannot This principle can be used to calmly and easily encourage livestock through crowding pens, chutes, and squeezes.
  • Page 4: Features

    Features • Fits any RC19M or RC22M. • Infinite Locking System. • Bolt-on design for easy installation. • Easy to use, simply lift the handle to raise the steer pusher out of the way as the steer enters the chute, then lower the handle to set the push bar in place. •...
  • Page 5: Table Of Contents

    Chute, and understand the operations of the Chute this Steer Pusher will be installed on. Rear Gate Front Gate If the Operators Manual for the chute is not available, contact Priefert Customer Service listed at the begining of this Manual to obtain a copy. AI_RC22SP_v1-0623.indd...
  • Page 6: Rc22Sp Installation

    RC22SP Installation Step 1 - Replace Trip Latch Handle Start by pushing Trip Latch Handle to Latch Handle Bolts release front gate. Use a Ratchet wrench or Impact and Box-end wrench to remove the upper and lower Latch Handle bolts, and remove Latch Handle (Fig 1).
  • Page 7: Step 4 - Install Latch Box

    Step 3 - Install Steer Pusher Assembly continued Repeat attachment of side support and mounting bracket on opposite side (Fig 10), so pusher assembly is mounted to top rails of chute (Fig 11) Securely tighten these six (6) bolts & nuts with Ratchet or Impact Wrench and Socket.
  • Page 8: Appendix

    Jill Webster Ph.D., & Mark Gonzalez; Livestock Safety; Agricultural Systems Technology and Education, Utah State University Extension; Utah State University , <http://extension.usu.edu/files/publications/factsheet/AHS-11.pdf> Suggested References Priefert assumes no liability for the use or misuse of information provided in the following references: PRCA, prorodeo.com; Rodeo Terminology, 2021 https://www.prorodeo.com/prorodeo/rodeo/rodeo-terminology The Team Roping Journal;...
  • Page 9: Warranty

    Proper venue for any lawsuits arising from or related to this limited warranty shall be only in Titus County, Texas. Priefert may waive compliance with any of the terms of this limited warranty, but no waiver of any terms shall be deemed to be a waiver of any other term.
  • Page 10 AI_RC22SP_v1-0623.indd...

Table of Contents