Priefert Q36 Installation Instructions Manual

Solar box

Advertisement

Quick Links

Q36 Solar Box
Installation Instructions
www.priefert.com 800-527-8616
IMPORTANT: Battery must be connected for
operation! Remove cover to connect power supply.
See page 4 of Assembly Instructions.
AI_Q39-Q36_v2-0123.indd

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Q36 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Priefert Q36

  • Page 1 Q36 Solar Box Installation Instructions www.priefert.com 800-527-8616 IMPORTANT: Battery must be connected for operation! Remove cover to connect power supply. See page 4 of Assembly Instructions. AI_Q39-Q36_v2-0123.indd...
  • Page 2: Using This Manual

    The power cell in the Q36 allows it to operate for periods when there Your model may vary in design and configuration from those shown in this is no sunlight to recharge the unit.
  • Page 3: Safety Alert Symbols

    Thoroughly read and understand the installation, operation, references and move depending on a handlers position relative to their point of balance. other material supplied with the Q36. If the installer or operator cannot read This principle can be used to calmly and easily be encourage livestock through crowding pens, chutes, and squeezes.
  • Page 4: Features

    Q36 Control Box "x "x 3" Mounting Plates w/Cover (1ea) "x 2 " Bolts "x 1" Bolt 1 - Q36 Enclosure w/Solar Panel " Lock Nuts 1 - Q36 Box Lid " Bolt "x " Lock Nut 1- Retaining Clip...
  • Page 5: Table Of Contents

    Suggested References ............4 Warranty Weather-proof Solar Panel Single-Button Control NOTE: Remote is packed inside Q36 Solar Box for shipping. Q36 Solar Box Q36 Remote Control TRANSQ36 Release Latch Trip Handle...
  • Page 6: Q36 Installation

    Step 2 - Install Pull Arm Fig 2 - Replace Release Latch Place Q36 Control Box on flat surface. Lay Solar Panel to the side. Remove and save four (4) cover screws, then remove Control Box cover. Remove the Remote and Leather Case from inside the Control Box and set aside.
  • Page 7: Step 4 - Control Box Location

    Attach the duplexed wire to the positive lead on the battery (Fig 10). The Q36 Control Box will not operate if this wire is not connected to the battery. NOTE: To maintain the charge of the storage battery during shipment, a protective plastic cap may cover the positive lead.
  • Page 8: Appendix

    Jill Webster Ph.D., & Mark Gonzalez; Livestock Safety; Agricultural Systems Technology and Education, Utah State University Extension; Utah State University , <http://extension.usu.edu/files/publications/factsheet/AHS-11.pdf> Suggested References Priefert assumes no liability for the use or misuse of information provided in the following references: PRCA, prorodeo.com; Rodeo Terminology, 2021 https://www.prorodeo.com/prorodeo/rodeo/rodeo-terminology The Team Roping Journal;...
  • Page 9: Warranty

    Proper venue for any lawsuits arising from or related to this limited warranty shall be only in Titus County, Texas. Priefert may waive compliance with any of the terms of this limited warranty, but no waiver of any terms shall be deemed to be a waiver of any other term.
  • Page 10 AI_Q39-Q36_v2-0123.indd...

Table of Contents