Table of Contents
Advertisement
Carton contents and item checklist
Unpacking the appliance
The heater is supplied in one carton. This contains the heater, standard rear panel set, screw pack,
and additional installation components—refer table below for details.
Remove all packaging materials and check for damage. If any damage is evident do not install or
operate the appliance—contact your place of purchase for advice.
Before installing the heater, check it is labelled for the correct gas type. Refer to the data label at
the rear of the heater.
The heater does not come supplied with flue components. These are purchased separately. Only
Rinnai Energysaver flue components can be used with this appliance.
Carton contents and item checklist, check you have:
•
One of the following Rinnai Energysavers
- RHFE-309FT3
- RHFE-561FT3
•
One rear panel set comprising of left, right, and top panels
•
One pack containing the following
PART
Plastic inlet hose clips (holds the air intake hose in place)
Air intake baffle ring* (ensures the max. efficiency on the heater)
Stainless steel sheath clamp (holds the protective sock on the
exhaust pipe in place)
Securing brackets (secures the heater to the wall)
Cable tie (secures the air inlet elbow onto the flue)
Flue lock clamp (secures the exhaust pipe assembly
onto the flue)
Screw pack
* The air intake baffle ring is only required to be installed on the 309, 559, and 561 models which use the ESDFK
component in a direct flue installation. It improves the efficiency of the unit slightly. It is not critical to the safe operation of
the unit and does not need to be fitted if it has been misplaced.
Plastic inlet hose clip
- RHFE-559FT3
- RHFE1005FT3
Stainless steel sheath
RHFE-1005FT3
0
0
1
2
1
1 - large
1- small
1
Cable tie
RHFE-309/559/561FT3
2
1
1
2
1
1 - small
1
Flue lock clamp
15
Advertisement
Table of Contents
