Greasing The Mower Deck - Toro 72902TE Operator's Manual

Greasing the Mower Deck

Service Interval: Yearly—Grease the pump-belt-idler
arm.
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Grease the mower deck idler-pulley pivot until
grease comes out the bottom
Figure 51).
Figure 50
Machine with Side Discharge Shown
Figure 51
Machine with Rear Discharge Shown
4. Grease the drive-belt idler arms
(Figure 50 or
g295792
10.
g192516
11.
(Figure 52).
45
Figure 52
5. Grease the deck-belt idler arms (rear discharge
machines only) as shown in
Figure 53
Machines with Rear Discharge Only
6. Remove the dust cap and adjust the caster
pivots.
Note:
Keep the dust cap off until greasing is
done.
7. Remove the hex plug.
8. Thread a grease fitting into the hole.
9. Pump grease into the fitting until it oozes out
around the top bearing.
Remove the grease fitting in the hole.
Install the hex plug and dust cap
g009030
Figure 53.
g024207
(Figure 54).