Table of Contents
Advertisement
Figure 113
1. 7.6 cm (3 inch) at position
A is correct
2. 8.3 cm (3-1/4 inch) at
position B is correct
10.
Fine-tune the adjustment nut on the front
deck-lift assembly by turning it
Note:
To increase the height, turn the
adjustment nut clockwise; to decrease the
height, turn the nut counterclockwise.
Note:
If the front deck links do not have enough
adjustment to achieve accurate cut height, you
can use the single-point adjustment to gain
more adjustment.
g009196
3. Measure here from the
blade tip to the hard
surface
4. Measure at position A and
B on both sides
(Figure
114).
1. Adjustment nut
2. Jam nut
11.
To adjust the single-point system, loosen the
2 bolts at the bottom of the height-of-cut plate
(Figure
115).
Note:
For rear-discharge machines, the mower
deck is attached in the back holes at the factory.
Refer to
Figure
holes for further adjustment when leveling the
mower deck.
1. Bolts at the bottom of the height-of-cut plate
75
Figure 114
3. Rear deck adjustment
4. Front deck adjustment
116. If needed, use the front
Figure 115
g027344
g027345
Advertisement
Table of Contents
