Preparing Drinks With Milk - Siemens TI9553X1RW connect Instruction Manual

en Operating the appliance
Notes
Any grounds residue in the grounds
■
shaft should be directed down the
shaft using a soft brush.
To prematurely stop dispensing the
■
drink, press the rotary selector
again.
For another drink with ground coffee,
■
repeat the procedure.
When ground coffee is used, the
■
aromaDoubleShot function is not
available.

Preparing drinks with milk

This appliance features an integrated
milk system.The milk system can be
used to prepare coffee drinks with milk,
as well as milk froth and warm milk.
You can choose between Espresso
Macchiato, Cappuccino,
Latte Macchiato, Caffe Latte, Café
cortado and Flat White.
Tip:
You can also use plant-based
alternatives to milk, e.g. soya milk.
Notes
While milk is being prepared, you
■
may hear a whistling sound. These
noises are emitted for technical
reasons and are normal.
Dried milk residues are difficult to
■
remove so always perform cleaning.
~ "Cleaning the milk system"
on page 34
The quality of the milk froth depends
■
on the type of milk or the
plant-based alternative used.
:
Warning
Risk of burns!
The milk system becomes very hot.
After use, always let it cool down before
you touch it.
18
Using the milk container
The milk container H has been
designed especially for use together
with this appliance. It is intended solely
for use in the household and for storing
milk in the refrigerator.
Important: The milk container can only
be connected if the milk system is
installed in the outlet system with an
adapter and hose. (~ Fig. #)
To remove the lid, press the marking
1.
and remove the lid. (~ Fig. ')
Pour in the milk.
2.
Press the lid onto the milk container
3.
until it engages.
Connect the milk container on the
4.
left of the appliance. The milk
container must engage.
Tip:
If the milk container runs empty
during dispensing, it can be filled and
connected again. Dispensing continues
automatically.
Coffee drinks with milk
The appliance is switched on. The water
tank and bean container have been
filled.
The milk container filled with milk is
connected.
Place a cup or a glass under the
1.
outlet system.
Use the rotary selector to select the
2.
desired drink.
The name of the drink and the currently
active values are shown on the display.
To change the settings for the
3.
selected drink.
~ "Adjusting beverage settings"
on page 20 ~ "Menu settings"
on page 25
To begin dispensing the drink, press
4.
the rotary selector.