Supermicro SuperServer 1029P-WTR User Manual page 83

Table of Contents

Chapter 6: BIOS

PCI PERR/SERR Support

Select Enabled to allow a PCI device to generate a PERR/SERR number for a PCI Bus Signal

Error Event. The options are Enabled and Disabled.

Maximum Read Request

Select Auto for the system BIOS to automatically set the maximum size for a read request

for a PCI-E device to enhance system performance. The options are Auto, 128 Bytes, 256

Bytes, 512 Bytes, 1024 Bytes, 2048 Bytes, and 4096 Bytes.

MMCFG Base

Use this item to select the low base address for PCIE adapters to increase base memory.

The options are 1G, 1.5G, 1.75G, 2G, 2.25G. and 3G.

NVMe Firmware Source

Use this item to select the NVMe firmware to support booting. The options are Vendor

Defined Firmware and AMI Native Support. The default option, Vendor Defined Firmware,

is pre-installed on the drive and may resolve errata or enable innovative functions for the

drive. The other option, AMI Native Support, is offered by the BIOS with a generic method.

VGA Priority

Use this item to select the graphics device to be used as the primary video display for system

boot. The options are Onboard and Offboard.

M.2 PCI-E 3.0 X4 OPROM