Supermicro SuperServer 1029P-WTR User Manual page 46

SuperServer 1029P-WTR User's Manual
Power LED/Speaker
On the JD1 header, pins 1-3 are for the power LED and pins 4-7 are for the internal speaker.
If you wish to use an external speaker, connect its cable to pins 1-4.
4-pin BMC External I
A System Management Bus header for IPMI 2.0 is located at JIPMB1. Connect the appropriate
cable here to use the IPMB I
definitions.
Chassis Intrusion
A Chassis Intrusion header is located at JL1 on the motherboard. Attach the appropriate cable
from the chassis to inform you of a chassis intrusion when the chassis is opened. Refer to
the table below for pin definitions.
NVMe I C Header
2
Connector JNVI C1 and JNVI
2
PCI-E peripheral cards. Please connect the I
NVMe Slots
Use the four NVMe slots (P1_NVME0, P1_NVEM1, P2_NVEM0, and P2_NVME1) to attach
high-speed PCI-E storage devices. These slots are available on the (-NT) model only.
Micro SD Card
There is one Micro SD memory card slot located at JSDCARD1 on the motherboard.
Speaker Connector
Pin Definitions
Pin Setting Definition
Pins 1-3 Power LED
Pins 4-7 Speaker
C Header
2
C connection on your system. Refer to the table below for pin
2
External I
2
Pin Definitions
Pin# Definition
1 Data
2 Ground
3 Clock
4 No Connection
Chassis Intrusion
Pin Definitions
Pin# Definition
1 Intrusion Input
2 Ground
C2 are a management headers for the Supermicro AOC NVMe
2
46
C Header
C cables to these connectors.
2