Supermicro SuperServer 1029P-WTR User Manual page 80

SuperServer 1029P-WTR User's Manual
•
Recovery Firmware Version
•
ME Firmware Status #1
•
ME Firmware Status #2
•
Current State
•
Error Code
PCH SATA Configuration
When this submenu is selected, the AMI BIOS automatically detects the presence of the
SATA devices that are supported by the Intel PCH chip and displays the following items:
SATA Controller
This item enables or disables the onboard SATA controller supported by the Intel PCH
chip. The options are Disable and Enable.
Configure SATA as
Select IDE to configure a SATA drive specified by the user as an IDE drive. Select AHCI to
configure a SATA drive specified by the user as an AHCI drive. Select RAID to configure a
SATA drive specified by the user as a RAID drive. The options are IDE, AHCI, and RAID.
SATA HDD Unlock
This feature allows the user to remove any password-protected SATA disk drives.
Aggressive Link Power Management
When this item is set to Enabled, the SATA AHCI controller manages the power usage of
the SATA link. The controller will put the link in a low power mode during extended periods
of I/O inactivity, and will return the link to an active state when I/O activity resumes. The
options are Disabled and Enabled.
*If the item above "Configure SATA as" is set to RAID, the following items will
display:
SATA Port 0 ~ Port 7
This item displays the information detected on the installed SATA drive on the particular
SATA port.
•
Model number of drive and capacity
•
Software Preserve Support
80