Table of Contents
Advertisement
DO207S
Remove the single screw securing the battery strap. Lift of the battery strap.
Carefully lift out the battery pack and disconnect the terminals.
Connect the terminals to the new battery pack taking care to connect the black lead to
the negative connector first and the red lead to the positive connector second. Place the
new battery into the battery compartment.
Tuck the wiring inside the battery compartment so that the wiring does not interfere
with the battery compartment cover when it is replaced.
Re-install the battery strap and battery compartment cover.
WARNING : never use ordinary batteries for replacement, as these may leak and
damage your vacuum cleaner. Use only battery packs soled by your vendor.
CAUTION : never us the unit without the battery compartment cover in place.
NOTE : Any other servicing should be performed by an authorized service
representative.
CAUTION : Use only with the battery pack supplied with the unit.
Do not attempt to remove the battery pack from the unit to charge it.
Never attempt to throw the battery pack or unit into a fire or incinerate it.
Battery must be recycled or disposed of properly at the end of it's service life
according to the local laws and regulations.
WALL MOUNT BRACKET
Make sure that the untended wall area for the wall mounting bracket to be drilled is
free from any hidden electrical wires, water pipes and gas lines.
Select an appropriate place close to a wall power outlet.
Do not mount near direct sunlight, near a heat source or outdoors.
Carefully measure and mark the location of all bracket holes and then drill holes and
screw the wall mounting bracket onto the wall.
TROUBLESHOOTING GUIDE
Hand vac will not operate.
Possible reason : Batteries discharged.
Dead battery. Contacts between the unit and the charging stand are dirty. No power in
electrical outlet supplying transformer.
Possible solution : Charge unit. Replace batteries. Wipe and clean dirt from contacts.
Check fuse or breaker. Replace fuse/reset breaker.
Motorized brush will not work
Possible reason : The 2 metal pins of the motorized brush are not in contact with the
vacuum cleaner. Motorized brush is clogged up
Possible solution : Firmly insert the motorized brush into the air-intake nozzle. This
will connect the motorized nozzle to the unit power supply. Remove the lint, hair, etc.
from the motorized brush.
Hand vacuum will not pick-up.
Possible reason : Dust cup container is full. Dust cup filter needs cleaning or
replacement Unit needs recharging.
Possible solution : Empty dust cup container. Remove dust cup filtr and check for
38
Advertisement
Table of Contents
