Table of Contents
Advertisement
OPERATION
Ignition of the burner
WARNING!
Be very careful when you use open fire in kitchen environment. Manufacturer decline any
responsibility in case misuse of the flame
Always light the burner before you put cookware.
To light the burner:
1.
Turn the control knob counterclockwise to the maximum position (
down.
2.
Keep the control knob pushed for approximately 5 seconds; this will let thermocouple
to warm up. If not, the gas supply will be interrupted.
3.
Adjust the flame after it is regular.
If after some tries the burner does not light, check if the crown and its cap are in correct
positions.
Each control knob has a pilot light. It lights up when you turn the control knob.
1
Burner cap
2
Burner crown
3
Ignition candle
4
Thermocouple
WARNING!
Do not keep the control knob pushed for more than 15 seconds.
If the burner does not light after 15 seconds, release the control knob, turn it into off posi-
tion and try to light the burner again after minimum 1 minute.
In the absence of electricity you can ignite the burner without electrical device; in this case
approach the burner with a flame, push the relevant knob down and turn it counter-clock-
wise to maximum gas release position.
Operation
1
2
3
4
13
) and push it
Advertisement
Table of Contents
