Transmitter Wiring - Emerson Rosemount 935 Reference Manual

Installation instructions
May 2023
6.9

Transmitter wiring

6.9.1 Wiring
To install the wiring:
Procedure
1. Release the back screw bolt
2. Remove the protective plug mounted on the transmitter conduit/cable entry inlet
3. Connect the wires to the required terminals
4. Connect the grounding wire to the ground screw located on the exterior of the
5. Place and secure the transmitter unit's back cover by screwing on the cover and
6.9.2 Terminal wiring
The contains 6 wiring terminals.
Table 6-5: wiring options
Terminal number
1
2
3
4
5
6
36
cover (Figure 6-2, Item N). The chamber is now exposed.
and pull the wires through the transmitter inlet
14 NPT or M25x1.5 explosion-proof conduit connection/cable gland to assemble the
cable/explosion-proof conduit to the receiver.
wiring diagram. See Terminal
receiver (Figure 6-4, Item C). The transmitter must be well grounded to earth
ground.
securing the back screw bolt.
(Figure 6-2, Item O), and open the transmitter back
(Figure
(Figure 6-4, Item B) according to the
wiring, and Figure A-4
Function
Power +24 VDC
Return –24 VDC
Spare
Spare
Spare
Spare
Reference Manual
00809-0100-4035
6-4, Item D). Use a ¾-in. –
in Wiring configurations.
Emerson.com/Rosemount