Receiver/Transmitter Mounting; Receiver Wiring - Emerson Rosemount 935 Reference Manual
Open path combustible gas detector
Hide thumbs
Also See for Rosemount 935:
- Reference manual (76 pages) ,
- Quick start manual (40 pages) ,
- Reference manual (28 pages)
Table of Contents
Advertisement
Installation instructions
May 2023
6.6
Receiver/transmitter mounting
Mount the transmitter or receiver with the tilt mount kit, P/N 888270. The tilt mount
enables the transmitter or receiver to be rotated up to 60° in all directions, with a fine
alignment of up to 10°.
6.6.1
Tilt kit
The following contents are included with the tilt mount kit (P/N 888270):
Table 6-3: Tilt mount kit
Item
Tilt mount
Screw
Spring washer
6.6.2
Transmitter and receiver installation
The transmitter and receiver can be installed in 2 ways with the same tilt mount. Refer to
Figure 6-1
To install the transmitter and receiver:
Procedure
1. Place the tilt mount holding plate (1) in its designated location and secure it with 4
2. Place the receiver, with its conduit/cable inlets pointing downwards, on the receiver
3. Repeat
6.7
Receiver wiring
To install the receiver wiring:
Procedure
1. Release the back cover secure bolt
2. Remove the protective plug mounted on the receiver conduit/cable entry inlet and
3. Connect the wires to the required terminals
32
and
Figure
6-2.
fasteners through 4 holes of an 8.5 mm diameter.
Note
•
Skip this step if the tilt mount is already installed.
•
Receiver removal for maintenance purposes does not require tilt mount removal.
holding plate of the tilt mount (B). Secure the receiver with M10 x 1.5 screws with
No. M10 spring washers (I, J). Secure the receiver to the tilt mount using Hex Key No.
7 for M10 x 1.5 screws (I).
Step 1
and
Step 2
cover
(Figure
6-2, Item N). The chamber is now exposed.
pull the wires through the receiver inlet
or M25x1.5 explosion-proof conduit connection/cable gland to assemble the cable/
explosion-proof conduit to the receiver.
wiring diagram. See
Receiver terminal
and
Figure A-4
in
Wiring
Quantity
1
1
1
for installing the transmitter.
(Figure
6-2, Item O), and open the receiver back
(Figure
6-3, Item D). Use a ¾-in. – 14 NPT
(Figure
wiring, and
configurations.
Reference Manual
00809-0100-4035
Type/model
888269
M10 x 1.5
Number 10
6-3, Item B) according to the
Figure
A-1,
Figure
A-2,
Figure
Emerson.com/Rosemount
A-3,
Advertisement
Table of Contents
