Assembly Instructions; Completion Of The Fence Kit - atd models ATD015 Instruction Manual

1. Detach component A x1 (fence panel) and place it on your worksurface.
Then detach component B x1 (gravel board) and place it below the fence
panel, as per the illustration below.
2. Detach component C x1 (concrete post). Apply glue to one side and
position, as per the illustration below.
Continue to glue the posts in position - the amount will vary depending on
the length you require.
We recommend the posts are spaced 22mm apart.
Next, turn over the model and begin gluing the posts inline with the posts
on the opposite side.
3. Once you've reached your desired length, trim the fence panel inline with
the last post. Alternatively, you can extend the fence by butting up two
components and bonding them using a fence post that's evenly distributed
across both components, as per the illustration below.
You have now completed the fence kit. We hope you enjoyed and
successfully built the kit! To view our other card kits, more products and find
your local stockist, visit www.atdmodels.co.uk
We'd love to see photos of your finished models. Please send them to
enquiries@atdmodels.co.uk for a chance to be featured on our social media pages.
© Copyright ATD Models | All Rights Reserved