Dodge JOURNEY 2019 User Manual page 79

Hide thumbs Also See for JOURNEY 2019:
Table of Contents

Advertisement

6. To release the seat belt, push the red button
on the buckle. The seat belt will automati-
cally retract to its stowed position. If neces-
sary, slide the latch plate down the webbing
to allow the seat belt to retract fully.
Lap/Shoulder Belt Untwisting Procedure
Use the following procedure to untwist a twisted
lap/shoulder belt.
1. Position the latch plate as close as possible
to the anchor point.
2. At about 6 to 12 inches (15 to 30 cm) above
the latch plate, grasp and twist the seat belt
webbing 180 degrees to create a fold that
begins immediately above the latch plate.
3. Slide the latch plate upward over the folded
webbing. The folded webbing must enter the
slot at the top of the latch plate.
4. Continue to slide the latch plate up until it
clears the folded webbing and the seat belt
is no longer twisted.
Adjustable Upper Shoulder Belt Anchorage
In the driver and outboard front passenger
seats, the top of the shoulder belt can be ad-
justed upward or downward to position the seat
belt away from your neck. Push or squeeze the
anchorage button to release the anchorage, and
move it up or down to the position that serves
you best.
Adjustable Upper Anchorage
As a guide, if you are shorter than average, you
will prefer the shoulder belt anchorage in a
lower position, and if you are taller than average,
you will prefer the shoulder belt anchorage in a
higher position. After you release the anchorage
button, try to move it up or down to make sure
that it is locked in position.
NOTE:
The adjustable upper shoulder belt anchorage is
equipped with an Easy Up feature. This feature
allows the shoulder belt anchorage to be adjusted
in the upward position without pushing or squeez-
ing the release button. To verify the shoulder belt
anchorage is latched, pull downward on the shoul-
der belt anchorage until it is locked into position.
WARNING!
• Wearing your seat belt incorrectly could make
your injuries in a collision much worse. You
might suffer internal injuries, or you could
even slide out of the seat belt. Follow these
instructions to wear your seat belt safely and
to keep your passengers safe, too.
• Position the shoulder belt across the shoul-
der and chest with minimal, if any slack so
that it is comfortable and not resting on
your neck. The retractor will withdraw any
slack in the shoulder belt.
• Misadjustment of the seat belt could reduce
the effectiveness of the safety belt in a crash.
• Always make all seat belt height adjust-
ments when the vehicle is stationary.
77

Advertisement

Table of Contents
loading

Table of Contents