Advertisement
INSTALLATION INSTRUCTIONS
IMPORTANT: READ CAREFULLY BEFORE INSTALLING FIXTURE.
WARNING: Risk of Fire/Electric Shock. If not qualified, consult an electrician.
WARNING: Risk of Electric Shock. Disconnect power at fuse or circuit breaker before installing or servicing.
WARNING: Risk of Burn. Disconnect power and allow fixture to cool before changing bulb or handling fixture.
WARNING: Risk of Personal Injury. Fixture may become damaged and/or unstable if not installed properly. Tighten all fixture components
to their recommended torque values.
WARNING: Risk of Fire/Electrical Shock. Upside down installation can result in overheating or accumulation of water in fixture.
Install right side up.
5. With the pole and fixture(s) raised into position, place the power tray
onto the hinges of the housing electrical compartment and let
it hang free. Locate the power connector plug and rotate the power tray
until the connection can be made with the mating connector in the
housing. Raise the powertray until the two wing screws engage and
tighten until fully snug.
6. Replace door on the hinges at the rear of the housing, rotate into
position, and assure that both latches are fastened securely.
FIXTURE MAINTENANCE
RELAMPING
1. Disengage both latches and open the door. Do not let the door swing
freely on the hinges.
2. Replace the lamp with the appropriate type and wattage and reassemble
the refractor to the upper housing. FIG. 3
3. Close the door and assure that the latches are securely fastened.
PLUG-IN STARTER REPLACEMENT
This procedure applies to fixtures with a plug-in type starter. Disengage
both latches and open the door. Do not let the door swing freely on the
hinges. Loosen the power tray thumb screws, unplug the power connector
as you lower the powertray, and continue lowering until the powertray
hangs free on the hinges. The starter is located in the position shown.
Remove and replace. Reverse the directions to secure the powertray and
the door after starter replacement.
1. Remove the plug-in starter from the receptacle and replace.
FIG. 4 and FIG. 5
2. Assure that the wing screws on the powertray and both latches on the
door are fastened securely.
These instructions do not claim to cover all details or variations in the equipment, procedure, or process described, nor to provide directions for meeting every possible contingency
during installation, operation or maintenance. When additional information is desired to satisfy a problem not covered sufficiently for user's purpose, please contact your nearest
representative.
Customer First Center 1121 Highway 74 South Peachtree City, GA 30269 770.486.4800 FAX 770.486.4801
Talon Medium
Sheet 2 of 3
7/23/08
FIG. 3
Powertray
Thumbscrews (2)
FIG. 5
FIG. 4
Plug-In Starter
NOTE: Specifications and dimensions subject to change without notice.
Visit our web site at www.cooperlighting.com
IMI-687SW
ADW081604
Advertisement
