Table of Contents
Advertisement
Chapter 5. Operating the System
Chapter 5. Operating the System
5.1 Starting the System
Caution: Once the EQ-99X system is properly set up, verify that all personnel that will be in contact with the system
are aware of the potential hazards involved as described in
responsibility of the user to verify that the EQ-99X system is safely being used.
This section assumes you are using of the EQ-99-RC Remote Control to provide local control. If using an alternative
control system, substitute the appropriate digital input and output lines from the table I/O Port Pin
the switches and LEDs described below.
1. Review the status LEDs on the power supply controller. The POWER ON LED should be lit, and neither the
CONTROLLER FAULT nor LAMP MODULE FAULT LEDs should be lit.
Figure 23.
Power Supply Controller "POWER ON" LED Illuminated
2. On the EQ-99-RC Remote Control, turn the OPERATE switch ON by placing the switch in the "up" position. The
LASER ON LED light illuminates, and laser light is now present in the lamp head.
EQ-99X Operation & Maintenance Manual
Chapter 1. Safety and Warranty
Information. It is the
Assignments for
33 of 45
Advertisement
Table of Contents
