Schumacher EV Series Manual page 9

EN - English
CONNECTING THE OUTPUT CABLE TO THE CHARGING
STATION
1. The output cable should have five wires visible at the end opposite
the EV connector. Insert the wires through the right-hand opening
on the bottom of the charging station.
2. Insert the wires into the appropriate connectors in the right terminal
block as illustrated in the wiring diagram below.
N (Neutral) - Blue Wire
L - Brown Wire
PE (Ground) - Green/
Yellow Wire
Signal - Red and
White Wire
3. Insert the two-pin plug (red and white wires) into the connector to
the left of the right terminal block.
4. Feed the output cable up into the charging station and secure by
screwing the outer plastic nut to the threaded ring. The threaded
ring must be securely tightened.
MOUNTING THE CHARGING STATION TO THE WALL
1. Using a drill fitted with a 5.5 mm drill
bit, drill two pilot holes into the stud
where indicated by the mounting
template.
2. Drive the 5.5 mm x 50 mm lag screw
without a rubber washer into the top
pilot hole, leaving the head of the screw
6-7 mm above the wall surface.
Signal
J1
- 9 -
N PE L