Choosing A Location - Schumacher EV Series Manual

EN - English

CHOOSING A LOCATION

1. This device shall be mounted at a sufficient height from grade such
that the height of the storage means for the coupling device is
located between 600 mm and 1.2 m above grade.
2. Before starting the installation, choose a general mounting location
for the unit. The unit may be installed indoors or outdoors. Ensure
that the unit is within easy reach of where the hardwired circuit will
be installed by a licensed electrician. The wiring leading into the
charging station should have some slack. The mounting location
should also allow the output cable with EV connector to have some
slack while in use.
3. Using a stud finder, locate a stud within the general mounting
location identified in the previous step. Use a pencil to mark the
location of the stud.
4. Next, use a level and a
pencil to mark a line to
designate the top of the
charging station when
installation is complete.
This is usually about 125
cm above the finished
floor. Use tape to attach
the mounting template so
that the top edge of the
template lines up with the
pencil line you just made.
ASSEMBLING THE CHARGING STATION
1. Lay the charging station on a flat
surface and remove the lower
front cover. Unscrew the single M4
screw at the bottom of the unit.
Set the screw aside for reassembly.
Then, slide the cover down and lift
to disengage the tabs at the top of
the front cover. Set aside the lower
front cover for reassembly.
- 6 -