Updating Nand Flash And Booting From It - Embest SBC8600B Quick Operation Manual

Hide thumbs Also See for SBC8600B:

Table of Contents

Embest Technology

6） Type 0 as shown in following EBOOT menu to continue booting process;

--------------------------------------------------------------------------------

Main Menu

--------------------------------------------------------------------------------

[1] Show Current Settings

[2] Select Boot Device

[3] Select KITL (Debug) Device

[4] Network Settings

[5] SDCard Settings

[6] Set Device ID

[7] Save Settings

[8] Flash Management

[9] Enable/Disable OAL Retail Messages

[a] Select Display Resolution

[b] Select OPP Mode

[0] Exit and Continue

Selection: 0

Wait for the end of booting process and then the updated WinCE system is ready

for use.

2. Updating NAND Flash and Booting from It

1） Please refer to the previous contents to learn how to format TF card. After TF

card formatting is done, copy MLO, EBOOTSD.nb0, EBOOTND.nb0, NK.bin and

XLDRNAND.nb0 from \WINCE700\image\ of the DVD-ROM to the TF card;

2） Insert the TF card on SBC8600B and short the jumper JP5, and then power it on;

When you see information counting down in seconds, please press Space key

on your PC's keyboard to enter EBOOT menu.

3） Type 8 in EBOOT menu to enter flash management sub-menu;

4） Type character groups 9-4-a, 9-3-b and 9-2-c in sequence to write XLDR,

Table 6

Continue Booting

SBC8600B-QSG-V1.2

Table of Contents