Checking The Auger Gearbox Oil Level - Toro Power Max Heavy Duty 928 OE Operator's Manual

1. Tab
2. 1/16 inch (1.5 mm)
4. If the auger/impeller cable is not properly adjusted, do
the following steps:
5. Loosen the jam nut (Figure 50).
1. Jam nut
6. Loosen or tighten the turnbuckle that adjusts the
tension on the cable (Figure 50).
7. Adjust the turnbuckle until you obtain the proper gap.
8. Tighten the jam nut.
9. Insert the 2 screws you previously removed on the belt
cover.
10. If the auger/impeller cable is properly adjusted but
a problem remains, contact an Authorized Service
Dealer.
Checking the Auger Gearbox
Oil Level
Service Interval: Yearly—Check the auger gearbox oil and
add oil if necessary.
Figure 49
Figure 50
2. Turnbuckle
1. Move the machine to a level surface.
2. Clean the area around the pipe plug (Figure 51).
1. Pipe plug
3. Remove the pipe plug from the gearbox.
4. Check the oil level in the gearbox. The oil should be at
the point of overflowing at the filler opening.
5. If the oil level is low, add GL-5 or GL-6, SAE 85-95
EP gear oil lubricant to the gearbox until the point of
overflow.
Note: Do not use synthetic oil.
6. Install the pipe plug in the gearbox.
24
1
G016782
Figure 51