Chamberlain SECURITY+ CG40CDM Owner's Manual page 25

Table of Contents

Advertisement

Available languages

Available languages

INSTALLATION STEP 12
Connect Door Arm to Trolley
Follow instructions which apply to your door type as
illustrated below and on the following page.
SECTIONAL DOORS ONLY
Make sure garage door is fully closed. Pull the emergency
release handle to disconnect the outer trolley from the
inner trolley. Slide the outer trolley back (away from the
pulley) about 8" (20 cm) as shown in Figures 1, 2 and 3.
Figure 1:
• Fasten straight door arm section to outer trolley with
the 5/16"x1" clevis pin. Secure the connection with a
ring fastener.
• Fasten curved section to the door bracket in the
same way, using the 5/16"x1-1/4" clevis pin.
IMPORTANT: The groove on the straight door arm MUST
face away from the curved door arm (Figure 4).
Figure 2:
• Bring arm sections together. Find two pairs of holes
that line up and join sections. Select holes as far
apart as possible to increase door arm rigidity.
Figure 3, Hole alignment alternative:
• If holes in curved arm are above holes in straight
arm, disconnect straight arm. Cut about 6" (15 cm)
from the solid end. Reconnect to trolley with cut end
down as shown.
• Bring arm sections together.
• Find two pairs of holes that line up and join with
bolts, lock washers and nuts.
Pull the emergency release handle toward the opener at
a 45° angle so that the trolley release arm is horizontal.
Proceed to Adjustment Step 1, page 27. Trolley will
re-engage automatically when opener is operated.
HARDWARE SHOWN ACTUAL SIZE
Nut 5/16"-18
Ring Fastener
Clevis Pin 5/16"x1-1/4"
(Door Bracket)
Clevis Pin 5/16"x1"
(Trolley)
Lock Washer 5/16"
Hex Bolt
5/16"-18x7/8"
Figure 1
Pulley
Ring
Fastener
Door
Bracket
Clevis Pin
5/16"x1-1/4"
Figure 2
Pulley
Nuts
5/16"-18
Door Bracket
Figure 3
Pulley
Nuts
5/16"-18
Figure 4
CORRECT
Straight
Door Arm
(Groove
facing out)
25
Inner
Trolley
Emergency
Release Handle
Straight Door Arm
Curved Door Arm
Lock
Washers
5/16"
Bolts 5/16"-18x7/8"
Lock
Washers
5/16"
Bolts 5/16"-18x7/8"
Cut this end
INCORRECT
Straight
Door Arm
Curved
Door
Arm
Outer Trolley
Clevis Pin
5/16"x1"
Curved
Door
Arm

Advertisement

Table of Contents
loading

This manual is also suitable for:

Security+ cg42cdm

Table of Contents