Repair Instructions; Dismantling The Starter - Husqvarna TrioBrake 550XPG Workshop Manual

7.1 Dismantling the starter

1
Loosen the four screws, which hold the starter
against the crankcase and remove the starter. See
figure 1a
2
Pull the cord out about 30 cm and lift it into the
notch on the outside of the starter pulley. Release
the tension in the return spring by letting the starter
pulley rotate anti-clockwise. See figures 1b and 2.
WARNING!
If the spring tension is activated
on the starter pulley, the spring
can fly out and cause personal
injury. Wear protective glasses.
3
Remove the clip in the centre of the pulley. Remove
the spacer and the pulley. See figure 3. Loosen the
screws on the cassette and remove the cassette
and spring.
Cleaning and inspection
Clean the parts and check:
• The starter cord.
• That the starter pawls on the flywheel are intact,
i.e. that they spring back to the centre and
move easily.
• To lubricate the return spring using light oil.

7 Repair instructions

Fig 1a
Fig 1b
Fig 2
Fig 3
Repair Instructions
29
English -