Advertisement
www.aeroplusrc.com
Using the pushrod supplied screw ball joints onto each end. The correct length will leave the aileron lined up to the inner part still attached to the
wing.
Using supplied bolts attach the pushrod at both ends. Check to see you have sufficient movement of the aileron. If not adjust.
Carry out the same procedure on the other wing.
Gas Engine
From the template that came with the engine, using the cross axis on the engine box mark the mounting holes.
Check the diameter of the required bolts and drill accordingly.
Mount the engine with the stand offs to the bulkhead. Remember to use large washers on the inside to spread the load and use plenty of nutlock.
Exhaust options. Depending on the engine many exhaust options are available. Standard muffler, Pitts Exhaust of canister with header.
If using a canister a bracket is already inside the model. Using silicon tubing it will hold the end of the canister.
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
