Advertisement
www.aeroplusrc.com
The closed loop wires are assembled in the plane; attach the rear ball joints to the rudder. Do this to both sides.
Fit the arm onto the rudder servo and crimp the wires to a taut tension
Tail Gear
Locate all parts as in picture, when assembling remember to nutlock all parts
Assemble the Gear as per photo
At the rear of the fuselage you will find a ply wood area, lay the CF gear on this and mark the 3 holes. Taking care to make sure it is straight.
Drill each hole with a fine drill and drop thin cyno into the holes to strengthen the wood.
Screw the CF gear on with the three supplied self taping screws.
Drill a hole in the base of the rudder for the rudder steering guide.
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
