Advertisement
www.aeroplusrc.com
Before gluing with cyano, place it over the thin rod.
Aileron Servos
The ailerons on the wings are pre‐glued. Check each one by gently pulling to make sure that they are secure
Remove the covering where the aileron horns are glued in place. Use either a soldering iron or a sharp knife
Using sand paper rough the area that will be glued into the aileron.
Glue both horns in with epoxy glue, use a bolt through the horns when gluing to make sure the alignment is correct.
Fit the aileron servo and drill fine holes where the servo screws will fit. Then apply thin cyano to strengthen the holes.
If required install a servo extension lead onto the servo, remember to use a servo plug clip.
Fit the servo and centre the servo arm.
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
