www.aeroplusrc.com
Landing Gear Assembly
To stop the fuselage getting damaged while the model is assembled we recommend fitting the landing gear first.
Parts
CF Landing Gear
2 x wheel pants
2 x wheels
2 x axles
4 x collets
4 x M3 bolts
Push each axle through the large holes and tighten up using 2 spanners.
Place a collet on the axle followed by the wheel, then another collet on the outside as per below diagram.
Do not tighten up the collets yet as the wheel needs to be fitted an equal distance within the wheel pant.
The U/C rakes forward so use the correct wheel pant per side. Put nutlock onto the 2 x factory fitted blind nuts on the wheel pant
Fit over the axle and secure with 2 x cap head bolts
Now line up the wheel in the centre of the wheel pant opening and tighten the collets. Remember to use nutlock and to make sure the wheel can
move freely.
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com