Table of Contents
Advertisement
All manuals and user guides at all-guides.com
First Time Battery Charge
Charge the battery before using the HC700-i for the first time
until the status LED inside the Power Button shows steady
green. While charging for the first time, the Status LED turns
to steady red. When battery is fully charged, the LED shows
steady green.
The HC700-i Cradle charges the battery most effectively
when it is at room temperature [approx. 68°F (20°C)]. The rec-
ommended battery charging temperature range is 32°F to
95°F (0
C to 35
°
Routine Battery Charge
A battery is recharged to 90% of its full capacity after
approximately three and a half hours. The battery is fully
charged after four hours. During the charge, the Status LED
inside the Power Button shows steady red and turns green
when charging is completed.
Important: The battery will not charge if the HC700-i is not
properly docked in the cradle.
Battery Replacement
When the battery
is drained, the
HC700-i automati-
cally enters "Criti-
cal Low Battery"
state and shuts
down all functions
(the screen turns
off) to preserve the
data in its mem-
ory. The HC700-i allows you to replace batteries without los-
ing information stored in its memory ("hot swap"). To avoid
losing data stored in the memory, a fresh battery must be
installed within 30 minutes after removing the drained bat-
tery.
To replace a battery perform the following steps:
C).
°
Hand-strap
Battery
Compartment
Figure 4. Battery Installation and Removal
Battery Snap
7
Advertisement
Table of Contents
