Celestron StarSense Explorer DOB Quick Setup Manual page 5

Hide thumbs Also See for StarSense Explorer DOB:

Table of Contents

Available languages

5. Attach the 3 feet (G1) to the bottom plate (D) using the 3 feet

screws (G2). Thread the screws fi rmly into the predrilled pilot

holes. Once installed, press the feet screw covers (G3) onto the

ends of the feet.

7. Use the two crescent wrenches to tighten the nut onto the

bolt. Hold the head of the bolt stationary with one crescent

wrench while using the other crescent wrench to tighten the nut.

DO NOT OVERTIGHTEN THE NUT! With some force, you

should still be able to move the steel washer underneath the

nut with your fi ngers. If the washer cannot be moved with your

fi ngers, slightly loosen the nut.

STEEL WASHER

TEFLON WASHER

PLASTIC CYLINDER

STEEL WASHER

6. Connect the assembly to the bottom plate (D). Place one of the

steel washers (H3) and the plastic cylinder (H4) onto the bolt

(H1). Then, insert the bolt through the central hole in the bottom

plate. Next, place the Tefl on washer (H5) over the plastic

cylinder (H4) now protruding from the bottom plate. Take the

assembled base and lower it onto the bottom plate so that the

plastic cylinder goes through the central hole in the top plate.

Now, place the remaining steel washer (H3) on the end of the

bolt protruding from the top plate. Thread the nut (H2) onto the

bolt. Go to Step 7 for instructions to tighten the bolt.

8. Install the base handle (J1) onto the outside of the front panel

(B) using the 2 handle screws (J2).

NUT

BOLT

ENGLISH |

Table of Contents

22472