Celestron StarSense Explorer DOB Quick Setup Manual page 4

Assembly
1
A1
A2
E
1. Connect the side supports (E) to the left side panel (A1) and
right side panel (A2) using 8 of the base assembly screws (F).
The supports go on the on the same side of the panels as the
Celestron logos.
3
A1
F
3. Connect the side panels (A1 & A2) to the front panel (B) using
8 of the base assembly screws (F). Make sure the Celestron
logos on the side panels face outward and the rubber bumper
on the front panel faces inward.
4 | ENGLISH
A2
B
2
F
2. Attach the rubber bumper (M) to the interior surface of the front
panel (B). There is a small spot on the front panel that indicates
where to place the rubber bumper. Remove the adhesive backing
from the bumper and press the bumper fi rmly onto the spot.
4
F
4. Connect the assembly to the top plate (C) using 11 of the base
assembly screws (F). Orient the top plate so the side with the
logo faces upward.
B
SPOT MARK
M
C
F