Download Print this page

Correct Use - Omron D2JW-011 Manual

Sealed ultra subminiature basic switch

Advertisement

D2JW
Separator (Order Separately)
Model
Separator for D2JW
Precautions
Cautions
Mounting Dimensions
Use M2.3 mounting screws with plain or spring washers to mount
the Switch. Tighten the screws to a torque of 0.20 to 0.29 N m {2 to
3 kgf cm}.
Mounting Holes
M2.3 mounting holes
4.8
Terminal Connection
To solder the lead to the terminal, apply a soldering iron rated at
30 W max. (temperature of soldering iron: 250 C max.) within 3 se-
conds.
If soldering is not carried out under the proper conditions there is a
danger of over-heating and subsequent heat damage. Applying a
soldering iron for too long a time or using one that is rated at more
than 30 W may degrade the Switch characteristics.
Degree of Protection
The D2JW satisfies the following test condition specified by the IEC
Publication 529:
Degree of protection: IP67
Test method:See the figure below.
É É É É É
Water
15 cm min
1m min
Leave for 30 minutes
É É É É É
Test piece
É É É É É
Note: Temperature difference between the test piece and wa-
ter must be 5 C or more.
ALL DIMENSIONS SHOWN ARE IN MILLIMETERS.
To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527.
Cat. No. B040-E1-1B
Two, 2.4 0.1 dia.
t=0.18
0.1
Leave the test piece in water for 30 min with the top of the test piece
submerged 15 cm or more below the water level and the bottom of
the test piece submerged 1 m or more below the water level.
This test is to check the ingress of water into the switch enclosure
after submerging the switch in water for a given time. Even if this test
condition is met, the switch cannot be used in water.
Protection Against Chemicals
Prevent the Switch from coming into contact with oil and chemicals.
Otherwise, damage to or deterioration of Switch materials may re-
sult.

Correct Use

Refer to pages 22 to 29 for common precautions.
Separator
When mounting the Switch on a metallic surface, be sure to use a
Separator between the Switch and the mounting plate.
D2JW
5

Advertisement

loading

This manual is also suitable for:

D2jw-01k1a1D2jw-01k11D2jw-01k31D2jw-01k21D2jw-011-mdD2jw-01k1a1-md ... Show all