Moving The Unit; Connections And Operating Controls On The Rear; Interfaces - ULT LAS260.1 Operating Instructions Manual

Moving the unit

CAUTION
Connections and
operating controls on
the rear
LAS 260.1 – Date 07/2023
Before moving the unit to a new location, first switch it off and
disconnect the mains plug.
The casters allow the unit to be easily moved without having to
lift it. The device can be pushed or pulled to the required new
location.
When moving the unit, do not pull or push the unit by the
connected collection element.
The unit must only be moved with the casters on level
surfaces. If it is moved with the casters on an inclined surface,
there is a risk that control over the unit could be lost, resulting
in personal injury or damage to the unit. Once you have
finished moving the unit to its new location, apply the brakes
on the casters again.

Interfaces

X1: Connection for the mains power supply
X2: M12 interface
S2: Bridge switch for remote ON/OFF
S3: ecoflow CS
F1: Mains voltage fuse (10.0 A)
P4: Pressure measurement port for service work

Connections and operating controls on the rear

®
switch and direct control
Page 21