Test Run The Whirlpool; Complete The Finished Wall; Clean-Up After Installation - Kohler К-1643 Installation Manual

Install water-resistant wall
material so the
paperbound edge is at
least 1/4" (6mm) above
the finished, concave
surface of the module

6. Test Run the Whirlpool

- Check all electrical connections, and make sure the electrical power to the whirlpool and in line heater is on.
- Make sure all union connections to the pump and in line heater are securely hand tightened.
- Verify that the pump banding straps have been cut.
- Fill the whirlpool to a level at least 2" (5cm) above the top of the highest jet.
- Operate the whirlpool for 5 minutes, and check all whirlpool piping connections for leaks.
- For additional information on whirlpool operation, see Confirm Proper Operation on Page 9.

7. Complete the Finished Wall

- If you have not already done so, carefully remove the protective tape from the module surfaces.
- Cover the framing with water resistant wall material so the paperbound edges are within 1/4" (6mm) of the finished, concave
surface of the module. Seal the joints between the whirlpool edges and the water resistant wall material with silicone sealant.
- Tape and mud the water resistant wall material. Install the finished wall to the water resistant wall material. Seal the joints
between the whirlpool rim and the finished wall material with silicone sealant.
- Install any extra grab bars or towel bars to the bridging previously installed. Follow the accessory manufacturer's
instructions.
- Install the shower door according to the manufacturer's instructions.

8. Clean-Up After Installation

- When cleaning up after installation, do not use abrasive cleansers, as they may scratch and dull the whirlpool surface. Use
warm water and a liquid detergent to clean the surface.
- Remove stubborn stains, paint, or tar with turpentine or paint thinner. Do not allow cleaners containing petroleum
distillates to remain in contact with any whirlpool surfaces for long periods of time. Remove plaster by carefully scraping
with a wood edge. Do not use metal scrapers, wire brushes, or other metal tools. Use a powder type detergent on a damp
cloth to provide mild abrasive action to any residual plaster.
A
1013862-2-
Å Å Å Å Å Å Å Å
Å Å Å Å Å Å Å Å
Å Å Å Å Å Å Å Å
Concave Surface
8
Î Î
Stud
Î Î
Î Î
Î Î
Î Î
Î Î
Furring
Strip
Î Î
Î Î
Î Î
Î Î
Apply a continuous
bead of silicone
sealant to the
nailing-in flanges
Kohler Co.