Table of Contents
Advertisement
6. A message displays showing that the installation was successful or that it has
7. When you are finished using the USB key, store it in a safe location. You may
Configure the software
Configure the software following these procedures.
Required information:
Fill out all the information in the following tables in order to navigate through the
Easy Setup wizard configuration:
Table 10. This table (optional) is useful for completing the Easy Setup wizard. The table entries serve as a guide
only. Enter the Value column with your system information.
Field
Value
System name
NetBIOS name
Time zone
Network Time
Protocol (NTP)
Server
Alternate NTP server
VLAN ID
Domain name
46
Storwize V7000 Unified: Quick Installation Guide
failed. If it failed then an error code is provided. Look for this error code in the
IBM Storwize V7000 Troubleshooting, Recovery, and Maintenance Guide (PDF on the
CD), under Installation error codes. This will show you what action to take.
need to use it for other tasks.
Notes
The name associated with the Storwize V7000 Unified
IP address (such as storwizeV7000)
Name associated with the file module management
address (for example, filemod1)
Note: To change the NetBIOS name after the initial
configuration, use the cfgcluster CLI command.
Refer to Time Zone List in the IBM Storwize V7000
Unified Information Center. Specify the number
corresponding to a location in the time zone where the
system is being installed. Example: If the machine is
being installed in Tucson, Arizona, USA, the best math
for the time zone is America/Phoenix, and the
corresponding number is 161.
Site NTP server address
Alternate NTP server if applicable
Optional. This list shows one or more Virtual LAN
Identifiers. A VLAN ID must be in the range from 2 to
4095. If you do not use VLANs then leave this field
blank. Restriction: VLAN 1 is not supported for Scale
Out Network Attached Storage client traffic. This
restriction is intended to prevent security exposure and
reduce the probability of network configuration errors.
VLAN 1 is used within the industry as the default or
native VLAN. Many vendors use VLAN ID value 1 for
management traffic by default. Configuring VLAN 1 as
available within the network can be a security
exposure because VLAN 1 might span large parts of
the switched network by default. Setting VLAN 1 for
user client traffic can require explicit steps that differ
by vendor and can be prone to configuration error.
This name is the public network domain name.
Example: customer.com
The Cluster Name and Domain Name are typically
used in combination. Example: cluster1.customer.com
Advertisement
Table of Contents
