Using Operator Files; Displaying Lens File - Sony MEMORY STICK HDC-950 Operation Manual

4-6 Setup Using the OPERATION Menu
LENS VTR S/S a) Assigns a function to the VTR
START/STOP button of the lens.
ZOOM DISP Sets the display position (RIGHT or
LEFT) of the zoom position on the
viewfinder.
a)Invalid when the camera control unit is not connected.
3
Rotate the MENU SEL knob/ENTER button to
align the arrow marker (c) with the item you want
to set, and push the MENU SEL knob/ENTER
button.
The arrow marker (c) will change into a "?" mark.
4
Rotate the MENU SEL knob/ENTER button to
change the setting to the desired value, and push
the MENU SEL knob/ENTER button.
To turn the D5600K gain amplifier on or off:
When color temperature is high, signal to noise
ratio of blue component becomes better as
compared to the correction with the CC filter. And
also, when lighting is dark and color temperature is
high, it is possible to correct color temperature
with sensitivity higher than CC filter.
Note
When you change the settings of the D5600K gain
amplifier, it is necessary to perform automatic
white balance adjustment.
For details, see "4-1-2 Adjusting the White Balance"
on page 4-2(E).
ASSIGNABLE switch settings:
Setting Function
OFF Assigns no function.
FAN MAX Assigns the function to maximize the
cooling fan rotation.
VTR S/S switch settings:
Setting Function
RET2 SW Assigns the ON/OFF function to display the
image of the return video signal 2 on the
viewfinde.
INCOM1 Assigns the ON/OFF function of the
intercom microphone 1.
INCOM2 Assigns the ON/OFF function of the
intercom microphone 2.
The "?" mark will change back to the arrow
marker (c), and the new setting will be saved.
4-22(E)
Chapter 4 Adjustments and Settings for Recording
5
To set the values for another items, repeat steps 3
and 4.
6
When the menu operation is completed, set the
DISPLAY switch to ON.
The menu display disappears from the viewfinder
screen, and the current status of the camera appears at
the upper and lower edges of the screen.

4-6-9 Using Operator Files

Using the OPERATOR FILE page, you can read and
write OPERATION and PAINT menu settings from/to
memory stick as operator files.
OPERATOR FILE page
<OPERATOR FILE>
cREAD (MS pCAM)
WRITE(CAMp MS)
PRESET
Item Contents
READ Reads data from a memory stick.
WRITE Saves data on a memery stick.
PRESET Restores the preset status set by
using the file menu.
For details on memory stick operatoin, refer to the System
Manual.

4-6-10 Displaying Lens File

Using the LENS FILE page, you can confirm the name
and the f-stop (iris setting) of the lens in use.
1
Set the DISPLAY switch to MENU.
2
Turn the MENU SEL knob/ENTER button, to
display the FILE FILE page, then press the MIC/
MENU knob/ENTER button.
9