Related Manuals for Uni-Mig Workshop 270SWF
Summary of Contents for Uni-Mig Workshop 270SWF
- Page 1 UNI FLAME AUTOLIFT WORKSHOP 270SWF Seperate Wire Feeder Manual 240 Volt Standard MIG / MAG...
-
Page 2: Table Of Contents
YEARS Warranty Machine Model Description Part Number UNIMIG Workshop 270SWF KUM270SWF CONTENTS PAGE No: Safety General Description Operation Parts List Machine Parts Welding Tips Maintenance Trouble Shooting *** CAUTION *** Do not heat, cut or weld tanks, drums or containers until the proper steps have been taken to insure that such procedures will not cause flammable or toxic vapours from substance inside. -
Page 4: Safety
SAFETY... - Page 5 SAFETY...
-
Page 6: General Description
♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦... -
Page 7: Operation
♦ ♦ ♦ ♦... - Page 8 All electrical repair’s must be carried out by a Licensed Technician, The machine must be disconnected from the electrical supply before any repairs are made to the machine. If the fault of the equipment remains or is caused by an unknown reason, contact the service division! ⇒...
-
Page 9: Parts List
⇒ ⇒ ⇒ ⇒ ⇒ ⇒ → → → → → → All electrical repair’s must be carried out by a Licensed Technician, The machine must be disconnected from the electrical supply before any repairs are made to the machine. If the fault of the equipment remains or is caused by an unknown reason, contact the service division! ∅... - Page 10 ∅ ∅ ∅ ∅ ∅ ∅ ∅ ∅...
-
Page 12: Welding Tips
Welding Tips ∅ ∅ ♦ ♦ ♦ ∅ ∅ ♦ ♦ ∅ ♦... - Page 13 Welding Tips...
-
Page 14: Maintenance
MAINTENANCE WARNING: Exposure to extremely dusty, damp, or corrosive air is damaging to the welding machine. In order to prevent any possible failure or fault of this welding equipment, clean the dust at regular intervals with clean and dry compressed air of required pressure.
Need help?
Do you have a question about the Workshop 270SWF and is the answer not in the manual?
Questions and answers