Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Troubleshooting
Related Manuals for Uni-Mig WORKSHOP 255
Summary of Contents for Uni-Mig WORKSHOP 255
- Page 1 UNI FLAME AUTOLIFT WORKSHOP 255 Compact MIG Manual 240 Volt Standard MIG / MAG...
- Page 2 YEARS Warranty Machine Model Description Part Number UNIMIG Workshop 255 KUM255 CONTENTS PAGE No: Safety General Description Operation Parts List Machine Parts Welding Tips Maintenance Trouble Shooting *** CAUTION *** Do not heat, cut or weld tanks, drums or containers until the proper steps have been taken to insure that such procedures will not cause flammable or toxic vapours from substance inside.
- Page 4 SAFETY...
- Page 5 SAFETY...
- Page 6 ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦...
- Page 7 ♦ ♦ ♦...
- Page 8 All electrical repair’s must be carried out by a Licensed Technician, The machine must be disconnected from the electrical supply before any repairs are made to the machine. If the fault of the equipment remains or is caused by an unknown reason, contact the service division! All electrical repair’s must be carried out by a Licensed Technician, The machine must be disconnected from the electrical supply before any repairs are made to the machine.
- Page 9 ⇒ ⇒ ⇒ ⇒ ⇒ ⇒ ⇒ ⇒ ⇒ → → → → → →...
-
Page 10: Welding Tips
Welding Tips ∅ ∅ ♦ ♦ ♦ ∅ ∅ ♦ ♦ ∅ ♦... - Page 11 Welding Tips...
-
Page 12: Troubleshooting
MAINTENANCE WARNING: Exposure to extremely dusty, damp, or corrosive air is damaging to the welding machine. In order to prevent any possible failure or fault of this welding equipment, clean the dust at regular intervals with clean and dry compressed air of required pressure.