YEARS Warranty Machine Model Description Part Number UNIMIG Workshop 390SWF KUM390SWF CONTENTS PAGE No: Safety General Description Operation Parts List Machine Parts Welding Tips Maintenance Trouble Shooting *** CAUTION *** Do not heat, cut or weld tanks, drums or containers until the proper steps have been taken to insure that such procedures will not cause flammable or toxic vapours from substance inside.
Page 8
All electrical repair’s must be carried out by a Licensed Technician, The machine must be disconnected from the electrical supply before any repairs are made to the machine. If the fault of the equipment remains or is caused by an unknown reason, contact the service division! ⇒...
⇒ ⇒ ⇒ ⇒ ⇒ ⇒ → → → → → → All electrical repair’s must be carried out by a Licensed Technician, The machine must be disconnected from the electrical supply before any repairs are made to the machine. If the fault of the equipment remains or is caused by an unknown reason, contact the service division! ∅...
MAINTENANCE WARNING: Exposure to extremely dusty, damp, or corrosive air is damaging to the welding machine. In order to prevent any possible failure or fault of this welding equipment, clean the dust at regular intervals with clean and dry compressed air of required pressure.
Need help?
Do you have a question about the WORKSHOP 390SWF and is the answer not in the manual?
Questions and answers