Pioneer DDJ-SR Service Manual page 26

1
[4] Operation Test of the Velocity Sensitivity and Aftertouch for the Performance pads
A
Testing the velocity sensitivity and aftertouch of the operating elements shown below.
[Method to enter]
B
To enter the mode for testing the velocity sensitivity and aftertouch of the operating elements, after the unit starts in Service
mode, press the Rotary selector over 1 second. Performance pads 1 on both decks are lit and other LEDs are unlit.
[Method to exit]
Power-OFF.
Or, if the Rotary selector is pressed over 1 second again, all of Performance pad on both decks are unlit.
And the unit returns to normal Service mode.
[Operation method]
Press Performance pad or hold Performance pad pressed.
C
[Description of the modes]
D
• Values obtained in response to the speed of an initial keypress (velocity sensitivity) or the amount of force applied after initial
impact (aftertouch) will be converted to 8-step data (3-bit resolution).
• If the Performance pad on the left deck is held pressed, the number of the lit rubber pads on the right deck will
increase/decrease in response to force applied to the Performance pad on the left.
• If the Performance pad on the right deck is held pressed, the number of the lit rubber pads on the left deck will
increase/decrease in response to force applied to the Performance pad on the right.
(With the minimum amount of force applied, one LED is lit, and with the maximum amount of force applied, all 8 LEDs are lit.)
[Display examples]
• When the amount of force applied is minimum
(the converted value is "0"), only Performance pad LED 1
on the left (right) deck is lit.
E
• When the amount of force applied is medium
(the converted value is "3"), Performance pad LEDs 1–4
on the left (right) deck are lit and the other LEDs are unlit.
F
26
1
2
• When the amount of force applied is maximum
(the converted value is "7"), all Performance pad LEDs
on the left (right) deck are lit.
DDJ-SR
2
3
3
4
4